Dell PowerEdge FX2/FX2s Manual de usuario descargar pdf (Pagina 360)

100

101

Usage

Information

Port Channel interfaces are logical interfaces and can be either in Layer 2 mode (by

using the switchport command) or Layer 3 mode (by configuring an IP address).

You can add a Port Channel in Layer 2 mode to a VLAN.

A Port Channel can contain both 100/1000 interfaces and GE interfaces. Based on

the first interface configured in the Port Channel and enabled, the Dell Networking

OS determines if the Port Channel uses 100 Mb/s or 1000 Mb/s as the common

speed. For more information, refer to

channel-member.

If the line card is in a Jumbo mode chassis, you can also configure the mtu and ip

mtu

commands. The Link MTU and IP MTU values configured on the channel

members must be greater than the Link MTU and IP MTU values configured on the

Port Channel interface.

NOTE: In a Jumbo-enabled system, you must configure all members of a Port

Channel with the same link MTU values and the same IP MTU values.

Example

Dell(conf)#int port-channel 2

Dell(conf-if-po-2)#

Commands

channel-member — adds a physical interface to the LAG.

interface — configures a physical interface.

interface vlan — configures a VLAN.

minimum-links

Configure the minimum number of links in a LAG (Port Channel) that must be in “oper up” status for the

LAG to be also in “oper up” status.

Syntax

minimum-links number

Parameters

number Enter the number of links in a LAG that must be in “oper up”

status. The range is from 1 to 16. The default is 1.

Defaults 1

Command

Modes

INTERFACE

Command

History

Version 9.4(0.0) Supported on the FN I/O aggregator. This command is

supported in Programmable-Mux (PMUX) mode only.

Usage

Information

If you use this command to configure the minimum number of links in a LAG that

must be in “oper up” status, the LAG must have at least that number of “oper up”

360

1 2 ... 355 356 357 358 359 360 361 362 363 364 365 ... 461 462

Comentarios a estos manuales

Sin comentarios

Dell PowerEdge FX2/FX2s Manual de usuario Pagina 360

Comentarios a estos manuales

Relacionado con productos y manuales para Hardware De La Computadora Dell PowerEdge FX2/FX2s