
Example
• Reset the configuration on iDRAC.
racadm racresetcfg
The RAC configuration has initiated restoration to factory defaults.
Wait up to a minute for this process to complete before accessing the RAC again.
• Reset the KVM configuration on CMC.
racadm racresetcfg -m kvm
The configuration has initiated restoration to factory defaults.
• Reset blade 8 configuration from CMC.
racadm racresetcfg -m server-8
The RAC configuration has initiated restoration to factory defaults.
Wait up to a minute for this process to complete before accessing the RAC again.
• Reset when vFlash Partition creation is in progress.
racadm racresetcfg
A vFlash SD card partition operation is in progress. Resetting the iDRAC may corrupt
the vFlash SD card. To force racresetcfg, use the -f flag.
raid
Description Allows you to run the commands to control RAID arrays.
This subcommand is applicable only for iDRAC.
To run this subcommand, you must have the Configure iDRAC permission.
Synopsis
• racadm raid
• To generate and view information about the inventory of storage root node.
racadm raid get status
• To generate and view information about the inventory of controllers.
racadm raid get controllers -o
racadm raid get controllers -o -p <property names separated by
comma>
• To generate and view information about the inventory of batteries.
racadm raid get batteries -o
racadm raid get batteries --refkey <controller FQDD's separated
by comma>
racadm raid get batteries --refkey <controller FQDD's separated
by comma> -o
racadm raid get batteries --refkey <controller FQDD's separated
by comma> -o -p <property names separated by comma>
106
Comentarios a estos manuales