Dell Chassis Management Controller Version 4.50 Guía de usuario descargar pdf (Pagina 122)

100

101

• Disable flex address for fabric iDRAC.

racadm setflexaddr -f idrac 0

setled

Description Sets the state (blinking or not blinking) of the LED on the specified module.

To blink or unblink the chassis, I/O modules or the CMC, you must have the Debug Administrator

privilege on CMC. To enable the servers to blink or unblink, you must have the Server Administrator

or the Debug Administrator privilege on CMC. To run this subcommand for iDRAC, you must have the

Configure iDRAC permission.

Synopsis

For iDRAC:

racadm setled -l <ledState>

For CMC:

racadm setled -m <module> -l <ledState>

Input

• -m <module> — Specifies the module whose LED you want to configure.

<module> can be one of the following:

– server–n, where n=1–16

– server–nx, where n=1–8; x = a, b, c, d

– switch–n, where n=1–6

– cmc-active

– chassis

This option is applicable for CMC only.

• -l <ledstate> — Specifies whether the LED must blink.

<ledstate> can be one of the following:

– 0: no blinking

– 1: blinking

Example For CMC:

• racadm setled -m server-1 -1 1

LED state was set successfully.

• racadm setled -m server-9 -1 1

ERROR: Server in slot 9 is an extension of the server in slot 1.

NOTE: The setled command generates an error when run on the extension slot of a multi-

slot server.

For iDRAC:

racadm setled -l 1

LED state was set successfully.

122

1 2 ... 117 118 119 120 121 122 123 124 125 126 127 ... 427 428

Comentarios a estos manuales

Sin comentarios

Dell Chassis Management Controller Version 4.50 Guía de usuario Pagina 122

Comentarios a estos manuales

Relacionado con productos y manuales para Servidores Dell Chassis Management Controller Version 4.50