Dell Chassis Management Controller Version 4.50 Guía de usuario descargar pdf (Pagina 123)

setniccfg

Description Sets the iDRAC IP address. It displays an error message if the requested operation could not be

performed. A success message is displayed if the operation is completed successfully

To run this subcommand, you must have the Configure iDRAC permission.

NOTE: For CMC, the command helps to modify network configuration properties.

NOTE: The terms NIC and Ethernet management port may be used interchangeably.

Synopsis

• racadm setniccfg -d

• racadm setniccfg -d6

• racadm setniccfg -s <IPv4Address> <netmask> <IPv4 gateway>

• racadm setniccfg -s6 <IPv6 Address> <IPv6 Prefix Length> <IPv6

Gateway>

• racadm setniccfg -o

For CMC:

• racadm setniccfg -m <module> -v <vlan ID> <vlan priority>

• racadm setniccfg [-m chassis] -o

• racadm setniccfg –p [-6]

• racadm setniccfg -m <module> -k <speed> <duplex>

• racadm setniccfg -i <slot> -v <vlan ID> <vlan priority>

Input

• -d — Enables DHCP for the NIC (default is DHCP disabled.)

• -d6 — Enables AutoConfig for the NIC. It is enabled by default.

• -s — Enables static IP settings. The IPv4 address, netmask, and gateway must be specified.

Otherwise, the existing static settings are used. <IPv4Address>, <netmask>, and

<gateway> must be typed as dot-separated strings.

racadm setniccfg -s 192.168.0.120 255.255.255.0 192.168.0.1

• -s6 — Enables static IPv6 settings. The IPv6 address, Prefix Length, and the IPv6 Gateway can

be specified.

• -o — Enable or disable NIC.

• -i<slot> — Must be number n, where n=1–16

• -m<module> — Must be one of the following values:

– chassis — Default state if -m is not specified

– server–n: where n=1–16

– server–nx: where n=1–8; x=a–d (lower case)

– switch–n: where n=1–6

• -v — VLAN settings has following legal values: no arguments imply remove VLAN tag, not

compatible with server–nx (for example "server–4b") notation

<vlanid>=between 1 and 4000,

4021 and 4094, inclusive <vlan priority>=between 0 and 7, inclusive.

• -p — Disables IPv4(default) or IPv6 protocol.

• -k — Option has following legal values: no arguments imply autonegotiate <speed>=10, 100

<duplex> =half, full.

123

1 2 ... 118 119 120 121 122 123 124 125 126 127 128 ... 427 428

Comentarios a estos manuales

Sin comentarios

Dell Chassis Management Controller Version 4.50 Guía de usuario Pagina 123

Comentarios a estos manuales

Relacionado con productos y manuales para Servidores Dell Chassis Management Controller Version 4.50