Dell Chassis Management Controller Version 4.50 Guía de usuario descargar pdf (Pagina 46)

100

101

To block the firmware downgrade on 3000W AC power supply configuration.

racadm fwupdate –s

Ready for firmware update

racadm fwupdate –g –u –a 10.210.138.121 –d firming-4.40-A00.cmc

–m cmc-active

Firmware update has been initiated. This update process may

take several minutes to complete.

racadm fwupdate –s

Cannot update local CMC firmware: The uploaded firmware image

does not support the installed power supplies.

NOTE: Firmware update from local RACADM (using -p -u -d options) is not supported on

linux OS.

NOTE: For CMC, these commands specifically apply to an active-CMC update.

The following table describes the firmware update method supported for each interface.

FW Update Method iDRAC on Blade Servers iDRAC on Rack and Tower

Servers

CMC

Local RACADM Yes Yes No

Local RACADM-TFTP Yes Yes No

Local RACADM-FTP Yes Yes No

Remote RACADM Yes Yes Yes

Remote RACADM-TFTP Yes Yes Yes

Remote RACADM-FTP Yes Yes Yes

Firmware RACADM-TFTP Yes Yes Yes

Firmware RACADM-FTP Yes Yes Yes

get

Description You can read the value of configuration objects on the iDRAC and display RAC object values. The

currently used values by the device, are displayed.

If the values are pending, then commit and reboot job must be created using the jobqueue command.

For more information, see jobqueue.

This subcommand is applicable only for iDRAC.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 427 428

Comentarios a estos manuales

Sin comentarios

Dell Chassis Management Controller Version 4.50 Guía de usuario Pagina 46

Comentarios a estos manuales

Relacionado con productos y manuales para Servidores Dell Chassis Management Controller Version 4.50