
chassisaction
Description Executes a power action on the chassis, iKVM or a server.
This subcommand is applicable only for CMC.
To use this subcommand, you must have the Chassis Control Administrator privilege.
Synopsis
racadm chassisaction [-m <module>]<action>
Input
• -m <module> — Module on which you want to carry out the action. Values are:
• —chassis — is the default value if -m is not specified.
—switch-n where n=1–6
—kvm
• <action> — Action that you want to execute on the specified module. Values are:
• —powerdown — (Chassis only) Powers down the chassis.
—powerup — (Chassis only) Powers up the chassis.
—powercycle — Power cycles the module.
NOTE: If a server takes longer duration to turn off gracefully after the chassis power cycle is
initiated, CMC stops functioning indicating that graceful shutdown of the server was
unsuccessful. In this case, you must ungracefully turn off the system or try to gracefully turn
off the system again.
—nongraceshutdown — (Chassis only) Turns off the chassis ungracefully.
—reset — Performs a hard reset of the module.
When <module> = kvm or switch, <action> must be powercycle or reset.
Output
None
Example
Perform a reset of switch-3:
racadm chassisaction -m switch-3 reset
Module power operation successful.
clearasrscreen
Description
Clears the last crash (ASR) screen that is in memory.
For more information, see "Enabling Last Crash Screen" section in the
iDRAC7 User’s Guide
.
This subcommand is applicable only for iDRAC.
NOTE: To run this subcommand, you must have the Clear Logs permission.
Synopsis
racadm clearasrscreen
Input
None
Output
Clears the last crash screen buffer.
Example
racadm clearasrscreen
30
Comentarios a estos manuales